Frequently Asked Questions
How large of a tree or limb will the clipper cut?8" to 11" with a single cut. The deeper the tree goes into the blades, the larger cut. Longer shaped trees and limbs go deeper into the blades. How close to the ground will the clipper cut?
There is a sled on the bottom of the clipper which is used for blade support. To cut at ground level or below, tilt the cutter slightly forward and drop it to the ground in front of the tree. Next, slide clipper under the tree. The weight of the clipper will sink the clipper blades into the ground and allow you to cut at lower levels. What keeps tree from falling on operator?
Extreme caution must be taken. Though most cuts fall to the side, it is possible for a tree to fall backwards. To reduce the risks of trees falling backwards, trim limbs on the operator side of the tree before cutting. Also, tilting the clipper forward before cutting helps tree to fall away from operator. Will the clipper operate with all tractors and skid steers?
The clipper will operate with virtually all tractors and skid steers. The only requirement is to have a minimum hydraulic pressure of 2,000 PSI. How high will clipper reach
The HY-REACH Clipper will cut 6' beyond the end of your equipment. For example: If the loader reaches 12' in the air, add the 6' reach which means you can cut up to 18' in the air. How often should I sharpen the blade?
Never. The blades come with an approximate 1/8" edge. The force from the 5' X 8" cylinder forces the blades thru the tree so the blade does not need to be sharp. Sharpening the blade will only thin the steel and increase the possibilities of chipping the blade. Will rocks hurt the blade?
The blades are made of T1 steel. Dirt and rocks generally do not harm the blades. I only have one set of auxiliary hydraulic outlets on my tractor and the clipper and rotating head require four outlets.
You will need to purchase a 6-way, 2-position double selector valve. This will turn your one set of outlets into 2 sets and divert flow to two separate cylinders. These valves can be purchased from a dealer or as an accessory item. See accessories. A manual and a solenoid valve is available. How large is the cutting cylinder?
The cylinder is custom made for Precision Manufacturing. It is a 3,000 lb. 5 x 8 cylinder. How long have you been making the HY-REACH Clipper?
The clipper was first produced in 1992. Many improvements have been made since that time and we continually look for ways to improve our clipper. What kind of routine maintenance is required?
Just make sure all bolts and nuts are properly tightened before eash use and that all grease zerks are greased. Can I pile brush with the clipper?
The clipper is not designed for lifting. Doing so could permanently damage the clipper and/or accessories. How many trees will the clipper cut per hour?
There are too many variables to accurately answer this question since the cutting speed will vary depending upon the hydraulic pressure and flow. Generally, it takes slightly over 3 seconds to cut an 8" tree. Oweners have reported cutting up to 300 trees per hour. Can the clipper be used with equipment other than skid steers and tractors?
Yes. The clipper has been mounted to back hoes, excavators, telehandlers and bucket trucks to name a few. If equipment has hydraulics, a clipper can more than likely be adapted for use with that equipment. What type of trees will the clipper cut?
We are yet to find a wood that the clipper will not cut - DEAD OR ALIVE
